[ncl-install] After install to cygwin, no response to any command

Mary Haley haley at ucar.edu
Tue Sep 17 13:39:26 MDT 2013


Hi Robert,

Did you read this section of the Cygwin document that we provide:

http://www.ncl.ucar.edu/Download/cygwin.shtml#InstallCygwinX

It mentions that NCL will not work with the 64-bit setup-x86_64.exe code.  You must use the setup-x86.exe code when you install Cygwin.
We haven't created a NCL binary for 64-bit Cygwin yet.

--Mary

On Sep 17, 2013, at 11:11 AM, Robert Cohen <Robert.Cohen at po-box.esu.edu> wrote:

> Greetings,
>  
> I am attempting my second download of ncl-binary to Cygwin – the first was on a 32-bit desktop PC and this one is on a 64-bit laptop.
>  
> The first download went fine.  This download has a problem and I can’t find anything in the archives.
>  
> The problem is that every command (ncl, ncargf77, idt, ctrans, you name it) brings up no error, no response, nothing – just a blank line.  Using “which” brings up the proper locations and the files are indeed there.
>  
> If it brought up an error, I’d have a clue where to look.
>  
> I’m guessing there might be a missing library or something I neglected to install during the Cygwin setup but I need a clue where to look.
>  
> Any help would be appreciated.
>  
>  
> Robert A. Cohen, Department of Physics, East Stroudsburg University
> 570.422.3428   rcohen at esu.edu    http://www.esu.edu/~bbq
>  
> _______________________________________________
> ncl-install mailing list
> List instructions, subscriber options, unsubscribe:
> http://mailman.ucar.edu/mailman/listinfo/ncl-install



More information about the ncl-install mailing list