[ncl-install] NCL NCARG installation

[Mary Haley]

I'm afraid there's not much to go on here. Did you install the latest version of X/Cygwin by downloading the latest "setup.exe" from the X/Cygwin page (http://x.cygwin.com/), and running it?


--Mary

On May 15, 2012, at 1:51 AM, Jahanzeb Malik wrote:

> Dear NCL NCARG,
> I am trying to install and run NCL NCARG libraries on my System.  I have downloaded ncl_ncarg-6.0.0.CYGWIN_NT-6.1_i686.tar. I am using CYGWIN on Windows 7. My system is as: CYGWIN_NT-6.1-WOW64 with gcc (GCC) 4.5.3 . After unzip the downloaded NCL Version 6.0.0 precompiled binaries, OPeNDAP-enabled, I copied the extracted bin, include, and lib folders in c:\cygwin\home\ folder.  So now I have the contents of the BIN, LIB AND INCLUDE folders at the following location on my system:
>  
> C:\cygwin\home\bin
> C:\cygwin\home\include
> C:\cygwin\home\lib
>  
> Now when I type the command ncl –V, it yields
> -bash: /home/bin/ncl: Bad address
>  
> I will be very grateful to you if you please help me in resolving the issue!
>  
>  
> Best Regards
> M Jahanzeb Malik
> Water resources Dept, ITC
> University of Twente, The Netherlands
>  
> Mobile No.: +31 65 900 1285
> Off. Ph No.: +31 53 48 74 512
> Hom Ph No.: +31 53 48 03 999 ext/room 4110
>  
> _______________________________________________
> ncl-install mailing list
> List instructions, subscriber options, unsubscribe:
> http://mailman.ucar.edu/mailman/listinfo/ncl-install