[Wrf-users] plotting freezing level

[Tabish Ansari]

set up your hluresfile


On 13 November 2013 12:00, Geeta Geeta <geeta124 at hotmail.com> wrote:

> Hi All,
> I wish to plot the freezing level from WRF output. I am using following
> command.
>
> ga-> d fndlvl(tc,const(tc,0.0),lev=1000, lev=100)
>
> But my output only shows the contours over the sea areas. land area TC=0.0
> is not being plotted.
> One output is being attached (freez.png).
>
> Kindly suggest.
>
> geeta
>
> _______________________________________________
> Wrf-users mailing list
> Wrf-users at ucar.edu
> http://mailman.ucar.edu/mailman/listinfo/wrf-users
>
>


-- 
Thanks & Regards
Tabish Umar Ansari
MS Research Scholar
Environmental & Water Resources Engineering Division
Department of Civil Engineering
IIT Madras
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.ucar.edu/pipermail/wrf-users/attachments/20131113/2710a6e1/attachment.html